This type of pressure switch features a high degree of miniaturisation
and a modern attractive design.
It can be installed in any position and also mounted onto a wall by means
of two transversal holes.
In order to reduce wiring times, it is supplied ready assembled with
a 2-metre electric cable or an M8 connector with a 300-mm cable.
The contact is the switching type, which means it can be normally open
or normally closed.
A knurled push-lock handle is provided for regulation
Technopolymer adjusting push-lock handle
Brass adjusting screw
Steel piston spring
Body made of anodized aluminium
Technopolymer pressure switch body
Resin finish for IP65
Choke to reduce peaks in pressure
Adjustable pressure interval
Hysteresis (not adjustable)
Operating temperature range at: 1 MPa; 10 bar; 145 psi
Lower threaded port
Outside diameter of cable
Number of wires and cross section
Number of switchings
0.5 to 10
from 0.4 to 0.8 (See diagram)
3 x 0.5 mm
Normally-Open (NO) and Normally-Closed (NC)
5 x 10
Filtered lubricated or unlubricated compressed air. Lubrication, if used, must be continuous
In any position.