SOFT START VALVE
In addition to the main outlet, there are three supplementary air ports
with a 1/4” thread.
one for filtered non-regulated air (A) for use, for example,
with a compressed air gun.
two for filtered regulated air (B).
The unit comes complete with supplementary plugged ports for use
with A7 fittings.
ONE can be mounted inside the guard of the machine leaving only
the front visible. This is a considerable advantage in terms of functionality
and aesthetics as the user interface is entirely at the front.
Among the accessories to be ordered separately, there is the kit
of brackets for panel mounting.
A standard five-pin M12x1 connector, with IP67
protection is used for the opening solenoid
valve and the pressure switch.
One cable only is required, thus improving
reliability and reducing wiring times.
The soft start valve is an absolutely innovative feature among the functions provided by ONE.
Soft start valve available from the trade are generally based on the principle of leaving
the passage of a small amount of air until the downstream pressure reaches a set value,
and then opening the passage fully. In this way, the rate at which the pressure increases depends
on the flow rate of the utilities, which often feature a continuous flow rate, for example a blow,
and thus the starter can hardly activate. The solution offered by One is such that the pressure
increases gradually and it is independent of the flow rate of the utilities. Pressure increase can
be regulated precisely via the knob at the front.
Another piece of news, among the several possible configurations you can have the soft start valve
operated by the manual V3V
does not change with flow rate!
of conventional unit
Low flow rate: activation
High flow rate: activation
Even higher flow rate: never
ONE: LEARNING ABOUT